Search
Home Search

  • Common Mode Choke
    • July 02. 2021
    Common Mode Choke

    Common Mode Chokes When we said a common mode choke, it means it was wound both line and neutural windings on a single core. Since the noise would be common mode noise usually, the way to lower (if not eliminate) the unwant noise frequencies is to use a common mode choke As below picture show us details of Common-Mode Signals Defined: Such signals can arise from one or more of the following source...

  • Flat Wire Transformer Horizontal Plate Common Mode Chokes Line Filter
    • August 19. 2021
    Flat Wire Transformer Horizontal Plate Common Mode Chokes Line Filter

    Comparing round copper wire, flat copper wire with more excellent performance, higher current ( unit current density reach 1.5~2.0 times) & smaller volume (0.5~1.0 times). Lower DC resistance, extremely small capacitance distribution, perfect heat dissipation. Closed magnetic circuit design, small magnetic leakage, stable impedance balance, good conducted radiation effect and EMI effect. Autom...

  • The reasons that inductance can eliminate EMC
    • October 26. 2021
    The reasons that inductance can eliminate EMC

    During EMC power supply circuit design, common-mode interference is the most difficulties encountered, common mode inductor is one of the major methods on solving interference signals. Here let's talk about the basic principles of solving EMC artifacts from design plan in this way. A common mode inductance, is wound both line and neutural windings on a single core. While the magnetic flux in ...

  • Toroidal common mode choke for EMI suppression
    • April 15. 2022
    Toroidal common mode choke for EMI suppression

    Toroidal common mode choke for EMI suppression Chokes for EMC filters We plan use them before LED constant voltage 12V supply. Inductance 10mH or higher Rated current 1.5A Rated voltage 250VAC Insulation breakdown test (winding to winding) 60 sec @  1500VAC Design- horizontal PCB mount, through hole. Dimensions  must not exceed: 28*18-12cm, width and depth - 35mm   Main Application:...

  • High Magnetic permeability Common Mode Choke Core
    • May 27. 2022
    High Magnetic permeability Common Mode Choke Core

    With excellent technology support,Coilcore factory have strong ability to produce Commond Mode Choke coils, quality equal to Janpan MetalGlass enterprise's Standard,following 4 Series details description: 1). FT-3KMF4627H Seires (Equel to Coilcore's NT---G Series) FT-3KM Series Commom Mode Choke used in Single Phase, Three Phase Electronical application. 2).FT-3K50T Series ( Equel T...

  • Dicuss about Four-Phase Common Mode Choke
    • May 31. 2022
    Dicuss about Four-Phase Common Mode Choke

    The four-phase common mode choke is a four-terminal device, which founded by a nanocrystalline magnetic toroidal core as a common mode interference suppression device, four sets same size, same turns numbers coils wound symmetrically. When the common mode current flows, the magnetic flux in the magnetic ring superimposes each other, resulting in a considerable inductance, which has a suppressing e...

    A total of

    1

    pages

© Copyright: 2024 Guangzhou Amorphous Electronic Technology Co.,ltd. All Rights Reserved. 粤ICP备2021057165号

IPv6 network supported

IPv6 network supported

top

Leave A Message

Leave A Message

    If you are interested in our products and want to know more details,please leave a message here,we will reply you as soon as we can.

  • #
  • #
  • #
  • #